DT SWISS Assembly/Disassembly Tool For Ring Nut (Ratchet EXP)
Assembly/disassembly tool for ring nut found on Ratchet EXP hubs such as the 180, 240 (current gen) or current generation 1200 and 1501 series wheels as well as OE brands using this technology (Roval, Cannondal etc)
In stock
R925.00
In stock
- Field of application: Wheel/Hub servicing
- Weight [g]: 70.5
- Compatibility: DT Swiss Ratchet EXP hubs such as the 180 and 240 hubs (current gen) or OE brands using this technology in their wheels (Roval, Cannondale etc)
- Pairs with: Bearing disassembly tool for Ratchet EXP hubs
- Refer to our DT SWISS FAQ page for further info on tool use
You may also like…
Related products
-
DT Swiss, Spokes
DT SWISS Revolution® – J-Bend – Double Butted (1.5)
In terms of weight, DT Revolution is the lightest round spoke in the DT Swiss spoke range! The diameter of the middle section is reduced to 1.5 mm during the cold forging process. This slim centre piece saves 161 g in weight compared to spokes with a constant diameter. Its use is very versatile due to the ideal ratio between stability and low weight. DT Revolution is a reliable partner for anyone looking for a light wheel in a classic design. Weight: from 283 g for 64 spokes at a length of 264 mm.
SKU: n/a -
DT Swiss, Endcaps
DT SWISS 15mm End Caps For 350 And 370 Front Hubs
End caps for converting DT SWISS 350 and 370 hubs or wheels using these hubs (1900 and 1700 range) to 15mm thru axle
Converts both 100mm (standard) and 110mm (boost) hubs to 15mm thru axle, but DOES NOT convert standard hubs to boost, or vice versa – these hubs just share the same end caps. To convert to/from Boost one would need to change the hub shell itself
NOTE: DT SWISS hubs are not convertible to boost spacing (110mm) from standard spacing (100mm) and the use of aftermarket products to do so voids the product warranty
SKU: HWGXXX0004785S
