DT SWISS Bearing Installation Tool (1526 Bearings)
Hub service tool used for installation of 1526 bearings found in DT Swiss hubs such as the 180 and 240
Out of stock
R290.00
Out of stock
- Field of application: Hub service
- Weight [g]: 36
- Compatibility: DT Swiss hubs using 1526 bearings (180, 240)
- Refer to our DT Swiss FAQ page for further info on correct hub service techniques
You may also like…
Related products
-
-
DT Swiss, Endcaps
DT SWISS 15mm End Caps For 350 And 370 Front Hubs
End caps for converting DT SWISS 350 and 370 hubs or wheels using these hubs (1900 and 1700 range) to 15mm thru axle
Converts both 100mm (standard) and 110mm (boost) hubs to 15mm thru axle, but DOES NOT convert standard hubs to boost, or vice versa – these hubs just share the same end caps. To convert to/from Boost one would need to change the hub shell itself
NOTE: DT SWISS hubs are not convertible to boost spacing (110mm) from standard spacing (100mm) and the use of aftermarket products to do so voids the product warranty
SKU: HWGXXX0004785S -
DT Swiss, Front Hubs
DT SWISS 350 MTB Front Hub (Boost) – Jbend – 6bolt
Whoever is looking for the most affordable high performance hubs available, should take a very close look at the 350 hub line-up. The same performance as its even higher end cousins comes with slightly less weight optimized parts to offer the same reliability at a much lower cost. Being available in all standards and for any application, the 350 hub is for those who maybe like to ride the trails a little more than drooling over catalogs and specs.
SKU: n/a
